Briggs and stratton pulsa jet carburetor diagram

BRIGGS AND STRATTON PULSA JET CARBURETOR DIAGRAM GENERATOR
BRIGGS AND STRATTON PULSA JET CARBURETOR DIAGRAM MANUAL
BRIGGS AND STRATTON PULSA JET CARBURETOR DIAGRAM SKIN

Remove control panel, inverter, and fuel tank as described in the Troubleshooting section.

WARNING Exhaust heat/gases could ignite combustibles or structures resulting in death, serious injury and/or property damage.ДЎ5 Rewind Starter Replacement Disassemble Rewind Starter 1. Remove the spark arrester, if equipped, and inspect for damage or carbon blockage. Remove spark plug and inspect for pitting, corosion, cracks, or other signs of damage.ДЎ4 BRIGGSandSTRATTON.COM Inspect Muffler and Spark Arrester Inspect the muffler for cracks, corrosion, or other damage. Clean area around spark plug and remove spark plug boot (Figure 9). Loosen the four handle screws and remove the handle (Figure 8).

BRIGGS AND STRATTON PULSA JET CARBURETOR DIAGRAM SKIN

Used motor oil has been shown to cause skin cancer in certain laboratory animals.ДЎ3 Service Spark Plug 1.

CAUTION Avoid prolonged or repeated skin contact with used motor oil.

BRIGGS AND STRATTON PULSA JET CARBURETOR DIAGRAM GENERATOR

Disconnect the spark plug wire from the spark plug and place the wire where is cannot contact spark plug.ДЎ2 BRIGGSandSTRATTON.COM Changing Engine Oil If the generator is used under extremely dirty or dusty conditions, or in extremely hot weather, change the oil more often.When Adjusting Or Making Repairs To The Generator More frequent service is required when operating in adverse conditions noted below.ДЎ1 WARNING Unintentional sparking could cause fire or electric shock resulting in death or serious injury.

C - Choke Lever - Used when starting cold engine.ДЎ0 BRIGGSandSTRATTON.COM Maintenance Maintenance Schedule Follow the hourly or calendar interval, whichever occurs first. Turn to the вЂњOFFвЂќ position when not in use. When the engine is not in use, leave the vent lever in the вЂњOFFвЂќ position to reduce the possibility of fuel leakage.Д© Generator Components A - Fuel Tank Cap Vent Lever - Turn the vent lever to the вЂњONвЂќ position when operating the generator. The vent lever must be in the вЂњONвЂќ position for the engine to run. Keep at least 5 feet (152 cm) of clearance on all sides of generator including overhead.ДЁ BRIGGSandSTRATTON.COM Fuel Tank Cap Vent Lever The fuel tank cap is provided with a vent lever ( A, Figure 2) to seal the fuel tank.Generator supplies correct rated frequency and voltage when running at governed speed.Д§ WARNING Exhaust heat/gases could ignite combustibles or structures resulting in death, serious injury and/or property damage. Excessively low speeds impose a heavy load on generator. When using generator for backup power, notify utility company.Д¦ BRIGGSandSTRATTON.COM CAUTION Excessively high operating speeds could result in minor injury and/or equipment damage.Use approved transfer equipment to prevent backfeed bt isolating generator from electric utility workers.

Д¤ BRIGGSandSTRATTON.COM Important Safety Instructions WARNING The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm.ДҐ WARNING Generator voltage could cause electrical shock or burn resulting in death or serious injury. No part of this material may be reproduced or transmitted in any form without the express written permission of Briggs & Stratton Power Products Group, LLC.ДЈ Table of Contents Important Safety Instructions. This generator is rated in accordance with CSA (Canadian Standards Association) standard C22.Дў BRIGGSandSTRATTON.COM Briggs & Stratton Power Products Group, LLC P.O.

BRIGGS AND STRATTON PULSA JET CARBURETOR DIAGRAM MANUAL

POWERSMART SERIESв„ў INVERTER GENERATOR SERVICE AND REPAIR MANUAL MODEL 030473 279957GS Rev.

Briggs and stratton pulsa jet carburetor diagram